Note that passwords are case-sensitive. So far it hovers hands off, so i guess im ok re, settings. Beginners Beginners in RC start here for help. Sure the trims can be at 0 or neutral without using subtrims. The 6EXH does not have sub trim functions, so i had to make sure that it was mechanically set at 90 as best i could
|Date Added:||26 April 2006|
|File Size:||58.85 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Last edited by JohnBuckner; at Thread Tools Show Printable Version.
Futaba T6exhp Rc Controller For Sale in Letterkenny, Donegal from stephen
Vutaba a Poll to this Thread. Send a private message to mikemhh In order to be able to post messages on the HeliFreak forums, you must first register.
Remove Advertisements Sponsored Links. Posting Quick Reply – Please Wait. Quote message in reply?
I assume your are in the uk. Here is the frequency band chart for most of Europe and the UK. Use a real email address or you will not be granted access to the site. Hi, As a Noob i was wondering if someone could check to see if i have my radio settings set up correctly?
In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.
Futaba T6exhp Computerized Helecopter Transmitter
Thanks for taking the time to reply. Fuutaba Quote message in reply? Please click one of the Quick Reply icons in the posts above to activate Quick Reply.
They are very cheap on auction sites as most have gone over to 2. Beginners Beginners in RC start here for help. Please enter a valid email address for yourself.
Find More Posts by JohnBuckner. You can use any Futaba 35mhz receiver, single or dual conversion, ppm or pcm. Might want to throw a little expo in, percent in both cyclic channels actually helps the throws to be more linear. Also enable hold and set it to 0, make sure the motor is off in throttle hold, you can use this to carry it around when the fuhaba is live and not hurt yourself if you slip and hit the throttle stick.
You may not post new threads.
John OK found it and see you are from the UK so yes that Transmitter will work with Any FM PPM receiver and either single conversion or dual conversion will work but keep in mind if the Rx is single conversion it will require a single conversion type crystal and the same applies to dual conversion. Send a private message to JohnBuckner. Not real positive on this matter so do check locally.
Send a private message to nellsey. This page is the UK air: If the mechancial setup is correct, that is the way it should be.
Find More Posts by nellsey. So far it hovers hands off, so i guess im ok re, settings. The 6EXH does not have sub trim functions, so i had to make sure that it was mechanically set at 90 as best i could I believe the Futabas that were sold here in the north American market were sold as negative shift units but think this does not apply in the europeon market and Futabas were all positive shift.
Where are you located, is the 35Mhz band legal for your country?
Hi broke again, How can all your trim settings be zero, did you check your servo arms?? Find More Posts by mikemhh